Technical

Renold Velo CT is an evolution of our proven Synergy Technology platform supremely adapted to the demands of single speed cycles. At our factory in Hannover, Germany,  components are precision formed to close tolerances and then specially heat treated using Renold’s proprietary processes. Next, components are uniquely surface treated prior to assembly resulting in high strength and very low friction.  Following lubrication, each chain is proof loaded and tested prior to final inspection and packing at our UK Chain Centre in Manchester.

Product technical details:

  • Renold proprietary heat treatment of components for increased tensile strength
  • Proof loaded for minimal ‘running-in’ period
  • Nickel plated components for optimum integrity and corrosion resistance
  • Specially treated bearing surfaces for significantly reduced friction and increased wear performance
  • Pre-lubricated with Renold Synergy lubricant 
  • Includes Velo CT calibrated chain wear measurement tool
  • Chain specification: 1/2” x 1/8” x 112 links

Dis-assembling Connecting Links:

Remove the already installed connecting link by carefully following the instructions below:

  1. Remove the spring clip from the grooved pins using a pair of needle nose pliers
  2. Detach the loose fitting outer plate from the end of the pins
  3. Remove the connecting link from the chain

 Assembling Connecting Links:

  1. Insert the connecting link into the loose ends of chain
  2. Slide the loose-fitting outer plate over the both pins until it has passed the grooves entirely to permit insertion of the spring clip
  3. Now using a pair of needle noise pliers locate the spring clip so that it sits in both grooves on the connecting pins. Be careful that the close end of the spring clip is facing the direction of travel as can be seen in figure 3

Renold Velo CT Wear Gauge

The Renold Velo CT wear gauge has been specifically designed to accurately measure chain elongation without the need to remove it. To avoid problems with running, the chain should be replaced before elongation reaches 1%. The wear gauge itself has a unique serialisation number commemorating the 138 years that have passed since Hans Renold himself patented the bush roller chain design we know today.

This assessment of chain elongation has now been made quick and easy with the Renold Velo CT wear gauge and this simple maintenance step can improve efficiency and performance by replacing your chain when it is required!

The Renold wear gauge can be read as follows. The numbers at the gauge show the chain elongation in percent. If the gradation with a number on it fits between two rollers, the chain elongation has reached this value in percent. The first gradation means 0.5% chain elongation.

  • At 0.7% wear, replacement of the chain should be considered in order to maintain optimum performance
  • At 1.5% wear, immediate replacement of the chain is indicated in order to prevent the risk of damage to machinery or potential injury